weather

my weather station

1st build will use the ESP code for this https://www.youtube.com/watch?v=tBGwyXPJZEQ&ab_channel=MichaelKlements https://www.the-diy-life.com/diy-3d-printed-iot-weather-station-using-an-esp32/

What You Need For This Project Firebeetle ESP32-E IoT Development Board – https://bit.ly/2VYygmj Grove Sensors & Cables (Beginner Kit I Used) – https://amzn.to/3ANygnV Reed Switch – https://amzn.to/3iOKC9f Neodymium Magnets – https://amzn.to/3m0zB6W Lithium-Ion Battery Pack (better than my one) – https://amzn.to/3iOOFTe 3D Print Resin, White PLA Style - https://amzn.to/3sil6wr M5 Button Head Screw & Nuts – https://amzn.to/2UiIQUq Bearings - https://amzn.to/3xPyqcD Header Pins - https://amzn.to/2wY3k9g Breadboard Jumpers - https://amzn.to/37M12ZS

Tools & Equipment Used Voxelab Proxima 6.0 3D Printer (Amazon) – https://amzn.to/37PzO4k Voxelab Proxima 6.0 3D Printer (Voxelab Direct) - https://bit.ly/3xRQmn3 Fluke Multimeter - https://amzn.to/3snFyvY TS100 Soldering Iron - https://amzn.to/3yRPAaS Dremel Versatip Heat Gun / Soldering Iron - https://amzn.to/3g7MjNn

cal and setup I made an anemometer using one sensor and 4 magnets, that allows for balancing and higher accuracy

I would also use different sensors for temperature and pressure BMW280 , humidity, temperature and pressure in one simple package on i2c

calibration is best done in a car that has an open roof. and use GPS for speed , do a test in two directions for a few runs at 5,10,15,20 and 40 KM/h and use that data

2nd build better looking prints https://hackaday.com/2018/04/05/a-true-3d-printed-weather-station/ https://hackaday.com/2018/03/28/storm-detector-modules-dancing-in-the-rain/ https://www.thingiverse.com/thing:2849562